Cisco 90i Test Type

1.3.6.1.4.1.1570.1.6.3.1.2

This parameter indicates the type of test to perform. It has no effect until frxStartTest is set to start the test. 1=Set up a loopback and run a PN-2047 Bit Error Rate Test. 2=Run a (straightaway) PN-2047 Bit Error Rate Test. This test assumes a loopback has been manually set up somewhere downstream or another test set running PN-2047 BERT is connected downstream. 3=Send corrupted CRC on the DSL. This has no effect on the frame relay CRC, only the out-of-band DSL CRC (used for performance monitoring) is corrupted. 4=Set up a loopback at the specified location to loop the frame relay or PPP data in both directions. 5=Setup a local loopback on all 4 ports. frxTestPort and frxLoopLoc are ignored for this test.