With IPHost Network Monitor you can run simple snmp requests against a D-Link device in your network.
adslLoopDiagFailReason
ADSL Loop Diag Fail Reason
1.3.6.1.4.1.3646.1300.2.2.1.4.5
Fail reason if loop diagnostic is failed. no fail reason is reported (0) IfIndex is not invalid (1) used profile does not exist or is inactive (2) line card does not exist (3) HWAPI return error (4) cancelled by user (5) line initialization fail (6) no atu-r is detected (7) line doesn't enter show-time state (8) timeout, result is not available (9) port monitoring is performing, loop diag can not perform at the same time (10) ::= { adslLoopDiagObjects 5 } SYNTAX Gauge32 UNITS "bps Valid only while adslLoopDiagCurrStatus is success.
Back to ASKEY-ADSL-MIB MIB page.
IPHost Network monitor allows you to monitor adslLoopDiagFailReason on D-Link device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring D-Link access points right now.
