adsl2SCStatusLinImg - ADSL2 Sub-Carriers Status Lin Img - ADSL2-LINE-MIB

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a Cisco device in your network.

adsl2SCStatusLinImg

ADSL2 Sub-Carriers Status Lin Img
1.3.6.1.2.1.10.238.1.2.2.1.9

An array of up to 512 complex H(f) linear representation values in linear scale for the respective transmission direction. It is designed to support up to 512 (downstream) sub-carriers. The number of utilized values on downstream direction depends on NSCds, and on upstream direction it depends on NSCus. This value is referred to here as NSC. Each array entry represents the imaginary component [referred to here as b(i)] of Hlin(f = i*Df) value for a particular sub- carrier index i (0 <= i < NSC). Hlin(f) is represented as ((scale/2^15)*((a(i)+j*b(i))/2^15)), where scale is Adsl2SubcarrierLinScale and a(i) [provided by the Adsl2SubcarrierLinReal object] and b(i) are in the range (-2^15+1) to (+2^15-1). A special value a(i)=b(i)= -2^15 indicates that no measurement could be done for the subcarrier because it is out of the passband or that the attenuation is out of range to be represented. This parameter is only available after a loop diagnostic procedure. Each value in this array is 16 bits wide and is stored in big endian format.

Back to ADSL2-LINE-MIB MIB page.

IPHost Network monitor allows you to monitor adsl2SCStatusLinImg on Cisco device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco firewalls right now.

MIBs list