prtoutputremainingcapacity - prtoutputremainingcapacity - 8100

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a HP device in your network.

prtoutputremainingcapacity

prtoutputremainingcapacity
1.3.6.1.4.1.11.2.3.9.4.2.2.9.2.1.5

The remaining capacity of the possible output sub-unit capacity in output sub-unit capacity units (PrtCapacityUnitTC) of this output sub-unit. If this output sub-unit can reliably sense this value, the value is sensed by the printer and may not be modified by management requests; otherwise, the value may be written (by a Remote Control Panel or a Management Application). The value (-1) means other and specifically indicates that the sub-unit places no restrictions on this parameter. The value (-2) means unknown. The value (-3) means that the printer knows that there remains capacity for at least one unit. Refer to ftp://ftp.pwg.org/pub/pwg/pmp/drafts/pmib_031698.txt, for more details in the Standard Printer MIB. Additional information: Replaces PML NOT-READY-OUTBIN-FULL and STATUS-OUTBIN-FULL. The values reported for output sub-unit 1 (face-down, top bin) will be either (-3) if it is not full or (0) if it is full.Output sub-unit 2 (face-up, left side bin) does not have any sensing, so it will always report unknown (-2).

Back to 8100 MIB page.

IPHost Network monitor allows you to monitor prtoutputremainingcapacity on Hewlett Packard device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco multiplexers right now.

MIBs list