maximum-resource-saving-memory - maximum-resource-saving-memory - 8100

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a HP device in your network.

maximum-resource-saving-memory

maximum-resource-saving-memory
1.3.6.1.4.1.11.2.3.9.4.2.1.3.3.1.7

This object's name is misleading. This object returns the maximum amount of additional memory, in bytes, that can be dedicated to holding PDL permanent soft resources. Additional information: NOTE: The values listed below have not been verified on MoBY. The following numbers assume that IO-BUFFERING=eOff; if IO-BUFFERING<>eOff, the following numbers will be reduced by the value of IO-BUFFER-SIZE. Memory for resource saving is allocated in increments of 102400 bytes. Therefore, for each 1M (1048576 bytes) of memory added to the printer, 102400 bytes are made available to resource saving (and I/O buffering) and 24576 bytes are retained until an additional 102400 byte block can be made available. The value reported by this object is always rounded down to the nearest multiple of 102400. For a PCL-only printer, the value of this object is zero (all resource saving memory is dedicated to PCL). If PostScript is installed without a duplex unit, the value of this object is as follows: Zero if <7M memory is installed. 1048576 if 7M memory is installed and RESOURCE-SAVING=eOff. 1048576 if 7M memory is installed and RESOURCE-SAVING=eOn (note that this value will be reduced by the amount of memory allocated to PCL-RESOURCE-SAVING-MEMORY-SIZE and POSTSCRIPT-RESOURCE-SAVING-MEMORY-SIZE). 819200 if 7M memory is installed and RESOURCE-SAVING=eAuto. When RESOURCE-SAVING=eAuto, 819200 bytes of each 1M over 7M memory installed are allocated to PCL and PostScript (409600 each) with the remaining bytes added to this object. When RESOURCE-SAVING=eOn or eOff, all bytes over 13M memory installed are added to this object. If PostScript is installed with a duplex unit, the value of this object is as follows: Zero if <13M memory is installed. 1048576 if 13M memory is installed and RESOURCE-SAVING=eOff. 1048576 if 13M memory is installed and RESOURCE-SAVING=eOn (note that this value will be reduced by the amount of memory allocated to PCL-RESOURCE-SAVING-MEMORY-SIZE and POSTSCRIPT-RESOURCE-SAVING-MEMORY-SIZE). 1048576 if 13M memory is installed and RESOURCE-SAVING=eAuto. When RESOURCE-SAVING=eAuto, 810200 bytes of each 1M over 13M memory installed are allocated to PCL and PostScript (409600 each) with the remaining bytes added to this object. When RESOURCE-SAVING=eOn or eOff, all bytes over 13M memory installed are added to this object. The above listed values returned by this object will be reduced by the amount of memory added to PCL-RESOURCE-SAVING-MEMORY-SIZE and POSTSCRIPT-RESOURCE-SAVING-MEMORY-SIZE when RESOURCE-SAVING=eOn.

Back to 8100 MIB page.

IPHost Network monitor allows you to monitor maximum-resource-saving-memory on Hewlett Packard device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco mobile switches right now.

MIBs list