file-system-test-return-code - file-system-test-return-code - 8000

MIBs list

With IPHost Network Monitor you can run simple snmp requests against a HP device in your network.

file-system-test-return-code

file-system-test-return-code
1.3.6.1.4.1.11.2.3.9.4.2.1.1.10.1.3

This test object that will not be supported in any released product. Setting this object allows the next file system call return code to be specified or to simulate uninitialized or unistalled volumes. The POS will specify the binary format. Additional information: A three byte binary value. The first byte indicates what function is being effected by this set. value | function ------+------------------ 1 | PersFSCtl 2 | PersFSDirClose 3 | PersFSDirCreate 4 | PersFSDirDelete 5 | PersFSDirOpen 6 | PersFSDirRead 7 | PersFSDirReadStd 8 | PersFSDirRewind 9 | PersFSDirSeek 10 | PersFSDirTell 11 | PersFSFileClose 12 | PersFSFileDelete 13 | PersFSFileMove 14 | PersFSFileOpen 15 | PersFSFileRead 16 | PersFSFileSeek 17 | PersFSFileStatus 18 | PersFSFileWrite 19 | PersFSFlush 20 | PersFSVolChk 21 | PersFSVolFix 22 | PersFSVolInit 23 | PersFSVolStatus The return value of the function being effected will return the value -1 to indicate an error occurred. The second byte is the value returned by the next call to PersFSErrNo() (after the call being effected is called). Refer to the 'Copernicus Personality Interface Volume 2 Disk File System' documentation for a list of values returned by PersFSErrNo(). The third byte indicates which call to the specified file system routine will fail. A value of one means the first call will fail. A value of two means the second call will fail, and so on. Writing this object causes any previous write to this object to be invalidated. Note: The error triggering mechanism is actually implemented at the message interface to the file system rather than at the PersFSxxx() function call interface. This is easier to do, and it is better for NFS because NFS uses the message interface rather than the PersFSxxx() functions. Fortunately there is a one-to-one mapping between messages and PersFSxxx() functions so everything works out nicely. The printer will uninitialize the mass storage device if the first byte is one of the values listed below. value | meaning ------+------------------ 101 | Effects the printer state 102 | Effects the data on the device The Moby printer supports 3 volumes zero, so the second byte must be 0 - 2. The third byte has no meaning and must be zero.

Back to 8000 MIB page.

IPHost Network monitor allows you to monitor file-system-test-return-code on Hewlett Packard device via the SNMP protocol. Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco switches right now.

MIBs list