With IPHost Network Monitor you can run simple snmp requests against a HP device in your network.
Returns or changes the amount of resource saving memory set aside to hold permanent soft PCL resources. Additional information: The value returned by this object is the amount of Resource Saving memory currently dedicated to PCL, regardless of the value of RESOURCE-SAVING. For a PCL-only printer, the value of this object is zero. All memory is dedicated to PCL, but it is not shown as such. If PostScript is installed, the default value of this object is as follows: 0 if RESOURCE-SAVING=eOff. 0 if <12M memory is installed. 400K if >=12M memory is installed and RESOURCE-SAVING=eOn. 400K if =12M memory is installed and RESOURCE-SAVING=eAuto. plus 100K for each 1M over 12M memory installed. If RESOURCE-SAVING=eOn, this object can be used to set the amount of Resource Saving memory currently dedicated to PCL. The range of values supported by this object are: 0 (disables resource saving for PCL). 400K bytes through (400K bytes + value of MAXIMUM-RESOURCE-SAVING-MEMORY) in increments of 100K bytes. If a value is received that is greater than 0 and less than 400K bytes, it will be snapped to 400K bytes and a status of will be returned. If an unsupported value greater than 400K bytes is received, it will be snapped down to the nearest 100K value and a status of will be returned. Attempting to set this object when RESOURCE-SAVING is eAuto or eOff will cause a status of to be returned.
Back to 2100_snmp MIB page.
IPHost Network monitor allows you to monitor pcl-resource-saving-memory-size on Hewlett Packard device via the SNMP protocol.
Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring Cisco optical switches right now.