XYLAN-DS1-MIB DEFINITIONS ::= BEGIN -- RCSID information -- $RCSfile: xylan-ds1.mib,v $ -- $Revision: 1.3 $ $State: Exp $ -- $Date: 1998/01/15 00:40:10 $ -- $Author: eric $ -- xylan-ds1.mib -- Revision: 1.00 -- Date: January 16, 1997 -- Alcatel Internetworking, Inc. -- 26801 W. Agoura Road -- Calabasas, CA 91301 -- (818) 880-3500 -- support@ind.alcatel.com -- This module provides authoritative definitions for Alcatel Internetworking, Inc. -- enterprise-specific physical port parameters MIB. -- This module will be extended, as needed. -- Alcatel Internetworking, Inc. reserves the right to make changes in -- specification and other information contained in this document -- without prior notice. The reader should consult Alcatel Internetworking, -- Inc. to determine whether any such changes have been made. -- In no event shall Alcatel Internetworking, Inc. be liable for any incidental, -- indirect, special, or consequential damages whatsoever (including -- but not limited to lost profits) arising out of or related to this -- document or the information contained in it, even if Alcatel Internetworking, -- Inc. has been advised of, known, or should have known, the -- possibility of such damages. -- Alcatel Internetworking, Inc. grants vendors, end-users, and other interested -- parties a non-exclusive license to use this Specification in connection -- with the management of Alcatel Internetworking, Inc. products. -- Copyright (C) 1996, Alcatel Internetworking, Inc. All Rights Reserved. IMPORTS Counter, TimeTicks FROM RFC1155-SMI OBJECT-TYPE FROM RFC-1212 DisplayString FROM RFC1213-MIB xylanPportArch FROM XYLAN-BASE-MIB ; dsx1Port OBJECT IDENTIFIER ::= { xylanPportArch 1 } -- T1/E1 Physical Port Configuration Table dsx1PortConfigTable OBJECT-TYPE SYNTAX SEQUENCE OF Dsx1PortConfigEntry ACCESS not-accessible STATUS mandatory DESCRIPTION "A table of Dsx1 physical layer status and parameter information." ::= { dsx1Port 1 } dsx1PortConfigEntry OBJECT-TYPE SYNTAX Dsx1PortConfigEntry ACCESS not-accessible STATUS mandatory DESCRIPTION "An entry in the table, containing information about the physical layer of a Dsx1 interface." INDEX { dsx1PortConfigSlotIndex, dsx1PortConfigPortIndex } ::= { dsx1PortConfigTable 1 } Dsx1PortConfigEntry ::= SEQUENCE { dsx1PortConfigSlotIndex INTEGER, dsx1PortConfigPortIndex INTEGER, dsx1PortConfigIfType INTEGER, dsx1PortFdlRole INTEGER, dsx1PortNfasAlign INTEGER, dsx1PortConfigYelAlarmDetectEnable INTEGER } dsx1PortConfigSlotIndex OBJECT-TYPE SYNTAX INTEGER (1..9) ACCESS read-only STATUS mandatory DESCRIPTION "A unique value which identifies this HSM board slot." ::= { dsx1PortConfigEntry 1 } dsx1PortConfigPortIndex OBJECT-TYPE SYNTAX INTEGER (1..32) ACCESS read-only STATUS mandatory DESCRIPTION "A unique value which identifies this port." ::= { dsx1PortConfigEntry 2 } dsx1PortConfigIfType OBJECT-TYPE SYNTAX INTEGER { t1(1), e1(2) } ACCESS read-only STATUS mandatory DESCRIPTION "The type of interface." ::= { dsx1PortConfigEntry 3 } dsx1PortFdlRole OBJECT-TYPE SYNTAX INTEGER { network(1), user(2) } ACCESS read-write STATUS mandatory DESCRIPTION "Indicates Facility Data Link port role of this port. If the port role is network and fdlMode is set to AT&T 54016, then this port periodically sends AT&T performance requests to CI." ::= { dsx1PortConfigEntry 4 } dsx1PortNfasAlign OBJECT-TYPE SYNTAX INTEGER { enable(1), disable(2) } ACCESS read-write STATUS mandatory DESCRIPTION "This object indicates if framing criterion is based on bit 2 of Time Slot 0 NOT-FAS. This object only applies to E1." ::= { dsx1PortConfigEntry 5 } dsx1PortConfigYelAlarmDetectEnable OBJECT-TYPE SYNTAX INTEGER { enable(1), disable(2) } ACCESS read-write STATUS mandatory DESCRIPTION "This object indicates whether Yellow Alarm should be detected." ::= { dsx1PortConfigEntry 6 } -- T1/E1 Physical Port Statistics Table dsx1PortStatsTable OBJECT-TYPE SYNTAX SEQUENCE OF Dsx1PortStatsEntry ACCESS not-accessible STATUS mandatory DESCRIPTION "A table of Dsx1 physical port statistics." ::= { dsx1Port 2 } dsx1PortStatsEntry OBJECT-TYPE SYNTAX Dsx1PortStatsEntry ACCESS not-accessible STATUS mandatory DESCRIPTION "An entry in the table, containing information about the physical port statistics of a Dsx1 interface." INDEX { dsx1PortStatsSlotIndex, dsx1PortStatsPortIndex } ::= { dsx1PortStatsTable 1 } Dsx1PortStatsEntry ::= SEQUENCE { dsx1PortStatsSlotIndex INTEGER, dsx1PortStatsPortIndex INTEGER, dsx1PortStatsLossOfSignal Counter, dsx1PortStatsOutOfFrame Counter, dsx1PortStatsRedAlarmEvent Counter, dsx1PortStatsYellowAlarmEvent Counter, dsx1PortStatsSquelchAlarmEvent Counter, dsx1PortStatsBipolarVioEvent Counter, dsx1PortStatsAISEvent Counter, dsx1PortStatsCrcErrorEvent Counter, dsx1PortStatsOutOfSubMultiFrame Counter, dsx1PortStatsOutOfTs16MultiFrame Counter, dsx1PortStatsRemFrameAlarm Counter, dsx1PortStatsRemMultiFrameAlarm Counter, dsx1PortStatsFarEndBlkError Counter, dsx1PortStatsFramingBitError Counter } dsx1PortStatsSlotIndex OBJECT-TYPE SYNTAX INTEGER (1..9) ACCESS read-only STATUS mandatory DESCRIPTION "A unique value which identifies this HSM board slot." ::= { dsx1PortStatsEntry 1 } dsx1PortStatsPortIndex OBJECT-TYPE SYNTAX INTEGER (1..32) ACCESS read-only STATUS mandatory DESCRIPTION "A unique value which identifies this port." ::= { dsx1PortStatsEntry 2 } dsx1PortStatsLossOfSignal OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of Loss of Signals that have been detected on this port." ::= { dsx1PortStatsEntry 3 } dsx1PortStatsOutOfFrame OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of Out of Frames that have been detected on this port." ::= { dsx1PortStatsEntry 4 } dsx1PortStatsRedAlarmEvent OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of Red Alarm events that have been detected on this port." ::= { dsx1PortStatsEntry 5 } dsx1PortStatsYellowAlarmEvent OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of Yellow Alarm events that have been detected on this port. This object applies to T1 port only." ::= { dsx1PortStatsEntry 6 } dsx1PortStatsSquelchAlarmEvent OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of Squelch Alarm events that have been detected on this port." ::= { dsx1PortStatsEntry 7 } dsx1PortStatsBipolarVioEvent OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of Bipolar Violation events that have been detected on this port." ::= { dsx1PortStatsEntry 8 } dsx1PortStatsAISEvent OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of AIS events that have been detected on this port." ::= { dsx1PortStatsEntry 9 } dsx1PortStatsCrcErrorEvent OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of ESF CRC-6 Error events for T1 or CRC-4 Error Events for E1 that have been detected on this port." ::= { dsx1PortStatsEntry 10 } dsx1PortStatsOutOfSubMultiFrame OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of out of sub-multiframe events that have been detected on this port. This object only applies to E1 port." ::= { dsx1PortStatsEntry 11 } dsx1PortStatsOutOfTs16MultiFrame OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of out of TS 16 multiframe events that have been detected on this port. This object only applies to E1 port." ::= { dsx1PortStatsEntry 12 } dsx1PortStatsRemFrameAlarm OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of Remote Frame Alarm events that have been detected on this port. This object only applies to E1 port." ::= { dsx1PortStatsEntry 13 } dsx1PortStatsRemMultiFrameAlarm OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of Remote MultifFame Alarm events that have been detected on this port. This object only applies to E1 port." ::= { dsx1PortStatsEntry 14 } dsx1PortStatsFarEndBlkError OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of Far End Block Error events that have been detected on this port. This object only applies to E1 port." ::= { dsx1PortStatsEntry 15 } dsx1PortStatsFramingBitError OBJECT-TYPE SYNTAX Counter ACCESS read-only STATUS mandatory DESCRIPTION "Total number of Framing Bit Error events that have been detected on this port." ::= { dsx1PortStatsEntry 16 } END