-- ***************************************************************** -- -- CISCO-WAN-RPM-CONN-EXT-MIB.my: -- CISCO RPM(Router Processor Module)Connection Extension MIB -- -- June 1999, Siu-Man Leung -- May 2002, Subra Hegde -- -- Copyright (c) 1999,2002 by cisco Systems, Inc. -- All rights reserved. -- -- ***************************************************************** CISCO-WAN-RPM-CONN-EXT-MIB DEFINITIONS ::= BEGIN IMPORTS MODULE-IDENTITY, OBJECT-TYPE, Unsigned32 FROM SNMPv2-SMI TruthValue FROM SNMPv2-TC MODULE-COMPLIANCE, OBJECT-GROUP FROM SNMPv2-CONF ciscoWan FROM CISCOWAN-SMI cwAtmChanCnfgEntry FROM CISCO-WAN-ATM-CONN-MIB; ciscoWanRpmConnExtMIB MODULE-IDENTITY LAST-UPDATED "200205210000Z" ORGANIZATION "Cisco Systems, Inc." CONTACT-INFO " Cisco Systems Customer Service Postal: 170 W Tasman Drive San Jose, CA 95134 USA Tel: +1 800 553-NETS E-mail: cs-wanatm@cisco.com" DESCRIPTION "This MIB together with the CISCO-WAN-ATM-CONN-MIB support provisioning of PVC endpoints and SPVCs on the MGX's Route Processor Module (RPM)." REVISION "200205210000Z" DESCRIPTION "Importing Unsigned32 from SNMPv2-SMI." REVISION "200203180000Z" DESCRIPTION "Modified the range of cwrChanVirtualTemplate to be consistent with value supported in CLI. The Range has been modified from 0..25 to 0..200." REVISION "199909300000Z" DESCRIPTION "Initial Version of this MIB Module." ::= { ciscoWan 9 } cwRpmConnExtMIBObjects OBJECT IDENTIFIER ::= { ciscoWanRpmConnExtMIB 1 } cwRpmConnExt OBJECT IDENTIFIER ::= { cwRpmConnExtMIBObjects 1 } cwRpmChanExtTable OBJECT-TYPE SYNTAX SEQUENCE OF CwRpmChanExtEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "This table together with the 'cwAtmChanCnfgTable' support provisioning of PVC endpoints and SPVCs on an RPM. This table contains objects that are specific to RPM. This table is an augmentation to the 'cwAtmChanCnfgTable'." ::= { cwRpmConnExt 1 } cwRpmChanExtEntry OBJECT-TYPE SYNTAX CwRpmChanExtEntry MAX-ACCESS not-accessible STATUS current DESCRIPTION "Each entry contains RPM specific parameters for a connection endpoint on an RPM." AUGMENTS { cwAtmChanCnfgEntry } ::= { cwRpmChanExtTable 1 } CwRpmChanExtEntry ::= SEQUENCE { cwrChanSubInterface Unsigned32, cwrChanVcd Unsigned32, cwrChanAalEncapType INTEGER, cwrChanVirtualTemplate Unsigned32, cwrChanInArpInterval Unsigned32, cwrChanOamLoopbkTxInterval Unsigned32, cwrChanOamManage TruthValue, cwrChanOamRetryUpCount Unsigned32, cwrChanOamRetryDownCount Unsigned32, cwrChanOamRetryInterval Unsigned32 } cwrChanSubInterface OBJECT-TYPE SYNTAX Unsigned32 (0..4294967295) MAX-ACCESS read-create STATUS current DESCRIPTION "The RPM's backplane sub-interface for which this channel is configured. Sub-interface 0 means the switch port." DEFVAL { 0 } ::= { cwRpmChanExtEntry 1 } cwrChanVcd OBJECT-TYPE SYNTAX Unsigned32 (0..4095) MAX-ACCESS read-only STATUS current DESCRIPTION "Virtual Circuit Descriptor. A unique number which identifies a connection." ::= { cwRpmChanExtEntry 2 } cwrChanAalEncapType OBJECT-TYPE SYNTAX INTEGER { aal5ciscoPPP(1), aal5muxAPOLLO(2), aal5muxAPPLETALK(3), aal5muxDECNET(4), aal5muxIP(5), aal5muxIPX(6), aal5muxPPP(7), aal5muxVINES(8), aal5muxXNS(9), aal5nlpid(10), aal5snap(11), ilmi(12), qsaal(13) } MAX-ACCESS read-create STATUS current DESCRIPTION "ATM adaptation layer (AAL) and Encapsulation type. aal5ciscoPPP - For Cisco PPP over ATM. 'cwrChanVirtualTemplate' is required to be set for this type. aal5muxAPOLLO - For a multiplex (MUX) - type virtual circuit using the Apollo protocol. aal5muxAPPLETALK - For a MUX-type virtual circuit using the AppleTalk protocol. aal5muxDECNET - For a MUX-type virtual circuit using the DECnet protocol. aal5muxIP - For a MUX-type virtual circuit using the IP protocol. aal5muxIPX - For a MUX-type virtual circuit using the IPX protocol. aal5muxPPP - For a MUX-type virtual circuit using the PPP protocol. 'cwrChanVirtualTemplate' is required to be set for this type. aal5muxVINES - For a MUX-type virtual circuit using the VINES protocol. aal5muxXNS - For a MUX-type virtual circuit using the XNS protocol. aal5nlpid - Allows ATM interfaces to interoperate with HSSI. aal5snap - The only encapsulation supported for Inverse ARP. Logical Link Control/ Subnetwork Access Protocol (LLC/SNAP) precedes the protocol datagram. ilmi - Used to set up communication with ILMI. qsaal - A signalling type PVC used for setting up or tearing down SVCs." DEFVAL { aal5snap } ::= { cwRpmChanExtEntry 3 } cwrChanVirtualTemplate OBJECT-TYPE SYNTAX Unsigned32 (0..200) MAX-ACCESS read-create STATUS current DESCRIPTION "This object identifies the virtual template. The non-zero value need to be specified for Cisco PPP or MUX-type PPP encapsulation (i.e. cwrChanAalEncapType = aal5ciscoPPP or aal5muxPPP). The value 0 signifies that Virtual Template is not applicable. " DEFVAL { 0 } ::= { cwRpmChanExtEntry 4 } cwrChanInArpInterval OBJECT-TYPE SYNTAX Unsigned32 (0..60) UNITS "minutes" MAX-ACCESS read-create STATUS current DESCRIPTION "This specifies how often Inverse ARP datagrams will be sent on this channel. 0 will disable the InArp for this channel. This object is only supported for aal5snap encapsulation (i.e. cwrChanAalEncapType = aal5snap)." DEFVAL { 15 } ::= { cwRpmChanExtEntry 5 } cwrChanOamLoopbkTxInterval OBJECT-TYPE SYNTAX Unsigned32 (0..600) UNITS "seconds" MAX-ACCESS read-create STATUS current DESCRIPTION "This specifies how often to generate an OAM F5 loopback cell from this channel. 0 will disable generation of OAM F5 loopback cells." DEFVAL { 10 } ::= { cwRpmChanExtEntry 6 } cwrChanOamManage OBJECT-TYPE SYNTAX TruthValue MAX-ACCESS read-create STATUS current DESCRIPTION "This enables/disables OAM management for this channel. If set to true(1), OAM management is enabled." DEFVAL { false } ::= { cwRpmChanExtEntry 7 } cwrChanOamRetryUpCount OBJECT-TYPE SYNTAX Unsigned32 (1..600) MAX-ACCESS read-create STATUS current DESCRIPTION "Number of consecutive end-to-end F5 OAM loopback cell responses that must be received in order to change a PVC connection state to up. This object only applies if OAM management is enabled (i.e. cwrChanOAMManage = true)." DEFVAL { 3 } ::= { cwRpmChanExtEntry 8 } cwrChanOamRetryDownCount OBJECT-TYPE SYNTAX Unsigned32 (1..600) MAX-ACCESS read-create STATUS current DESCRIPTION "Number of consecutive end-to-end F5 OAM loopback cell responses that are not received in order to change a PVC connection state to down. This object only applies if OAM management is enabled (i.e. cwrChanOAMManage = true)." DEFVAL { 5 } ::= { cwRpmChanExtEntry 9 } cwrChanOamRetryInterval OBJECT-TYPE SYNTAX Unsigned32 (1..1000) UNITS "seconds" MAX-ACCESS read-create STATUS current DESCRIPTION "The frequency that end-to-end F5 OAM loopback cells are transmitted when a change in UP/DOWN state of a PVC is being verified. This object only applies if OAM management is enabled (i.e. cwrChanOAMManage = true)." DEFVAL { 1 } ::= { cwRpmChanExtEntry 10 } -- conformance information ciscoWanRpmConnExtMIBConformance OBJECT IDENTIFIER ::= { ciscoWanRpmConnExtMIB 2 } ciscoWanRpmConnExtMIBCompliances OBJECT IDENTIFIER ::= { ciscoWanRpmConnExtMIBConformance 1 } ciscoWanRpmConnExtMIBGroups OBJECT IDENTIFIER ::= { ciscoWanRpmConnExtMIBConformance 2 } -- compliance statements ciscoWanRpmConnExtMIBCompliance MODULE-COMPLIANCE STATUS current DESCRIPTION "The compliance statement for the Cisco MGX RPM connection management group." MODULE -- this module MANDATORY-GROUPS { ciscoWanRpmConnExtMIBGroup } ::= { ciscoWanRpmConnExtMIBCompliances 1 } -- units of conformance ciscoWanRpmConnExtMIBGroup OBJECT-GROUP OBJECTS { cwrChanSubInterface, cwrChanVcd, cwrChanAalEncapType, cwrChanVirtualTemplate, cwrChanInArpInterval, cwrChanOamLoopbkTxInterval, cwrChanOamManage, cwrChanOamRetryUpCount, cwrChanOamRetryDownCount, cwrChanOamRetryInterval } STATUS current DESCRIPTION "Objects related to ATM connection in RPM module." ::= { ciscoWanRpmConnExtMIBGroups 1 } END