This MIB module contains object definitions for managing the Fault Finder feature in web-capable HP devices.
IPHost Network Monitor offer an easy way of SNMP monitoring your Hewlett Packard network devices.
OID list for hpprocurve-v2-hpff
- that this agent is capable of monitoring.
- configuration information.
- if any, to be taken if a fault of this type is detected by the agent. Setting an instance of this object to 'none' will clear any previous state of the associated fault on all ports. This object is used to enable or disable the port disable feature for t ...
- fault warning threshold for this fault type. The agent will periodically check relevant statistics for each port for each type of fault. If the warning threshold has been exceeded, and fault warning action is enabled for that fault type, an hpicfFaultFind ...
- port disable threshold for this fault type. The value of an instance of this object MUST be greater than the value of the corresponding instance of the hpicfFfWarnTolerance. The agent will periodically check relevant statistics for each port for each type ...
- speed reduce threshold for this fault type. The value of an instance of this object MUST be greater than the value of the corresponding instance of the hpicfFfWarnTolerance, and less than or equal to the corresponding instance of hpicfFfDisablePortToleran ...
- the Fault Finder.
- information about a single fault.
- this log entry. The index for a particular log entry must not change, even though entries with lower valued indices have been deleted.
- added to the hpicfFfLogTable.
- physical component on which the fault was detected. On agents which do not implement the Entity MIB, this will contain the ifIndex of the offending port.
- physical entity indicated by hpicfFfLogPhysEntity.
- when this fault was detected.
- will always be logged as 'critical'. An agent may need to remove faults from the fault log in order to reclaim resources. If so, it must remove lower severity faults before removing higher severity faults. Faults at the same severity level should be rem ...
- value 'new'. A manager cannot set this object to 'new'. Setting this object to 'active' indicates that the fault has been displayed to a user. Setting this object to 'old' indicates that the agent should remove this fault from the log.
- access additional information about the fault which triggered the notification in which this object was sent.
- Fault Finder feature.
- discovered faults.
- Fault Finder feature, including the ability to reduce a port's media speed in the event of a fault.
Download IPHost Network Monitor (500 monitors for 30 days, 50 monitors free forever) to start monitoring network devices right now.