Nortel-Magellan-Passport-FrameRelayUniTraceMIB Download

frUniTraceRowStatusTable

This entry controls the addition and deletion of frUniTrace components.

frUniTraceRowStatusEntry

A single entry in the table represents a single frUniTrace component.

frUniTraceRowStatus

This variable is used as the basis for SNMP naming of frUniTrace components. These components can be added and deleted.

frUniTraceComponentName

This variable provides the component's string name for use with the ASCII Console Interface

frUniTraceStorageType

This variable represents the storage type value for the frUniTrace tables.

frUniTraceIndex

This variable represents the index for the frUniTrace tables.

frUniTraceOperationalTable

This group provides the operational attributes for the Trace component.

frUniTraceOperationalEntry

An entry in the frUniTraceOperationalTable.

frUniTraceReceiverName

This attribute should be set to the name of the desired trace receiver before starting a trace session. All available trace receivers are listed under the Trace Rcvr/ component. This attribute cannot be set while a trace is active.

frUniTraceDuration

This attribute specifies the duration, in minutes, of a trace session. A value of 0 indicates unlimited duration in which case a trace session remains active until a stop command is issued. The default duration is 60 minutes. This attribute cannot be set ...

frUniTraceQueueLimit

This attribute specifies the total number of bytes of traced data which may be queued for transmission to the trace receiver. When this limit is exceeded, incoming traced frames are discarded. This attribute can be set while a trace is active and takes ef ...

frUniTraceSession

This attribute is set automatically. It identifies the Trace Session component which is forwarding the trace data. This attribute is empty unless a trace is active.

frUniTraceFilterRowStatusTable

This entry controls the addition and deletion of frUniTraceFilter components.

frUniTraceFilterRowStatusEntry

A single entry in the table represents a single frUniTraceFilter component.

frUniTraceFilterRowStatus

This variable is used as the basis for SNMP naming of frUniTraceFilter components. These components cannot be added nor deleted.

frUniTraceFilterComponentName

This variable provides the component's string name for use with the ASCII Console Interface

frUniTraceFilterStorageType

This variable represents the storage type value for the frUniTraceFilter tables.

frUniTraceFilterIndex

This variable represents the index for the frUniTraceFilter tables.

frUniTraceFilterOperationalTable

This group provides the operational attributes for the Frame Relay Trace Filter component.

frUniTraceFilterOperationalEntry

An entry in the frUniTraceFilterOperationalTable.

frUniTraceFilterTraceType

This attribute specifies the level of filtering required for this trace session. A value of lmi indicates that Lmi frames are traced. A value of dlci indicates that frames from the Dlci specified by the tracedDlci attribute are traced. A value of badFrame ...

frUniTraceFilterTracedDlci

This attribute specifies a particular Dlci to trace. A value of zero specifies that all Dlcis are to be traced. This attribute can be set while a trace is active and takes effect immediately.

frUniTraceFilterDirection

This attribute specifies the direction of the data to be traced as viewed by the service. The values can be egress, and/or ingress. An egress value indicates frames outbound from the service. An ingress value indicates frames inbound to the service. This ...

frUniTraceFilterTracedLength

This attribute specifies the maximum number of bytes to trace per frame starting from the byte following the frame flag. If the frame length is longer than the value specified by this attribute, then the traced frame is truncated. This attribute can be se ...